NSEE EG22A 24V DC Circuit Control Board PCB Automatic Swing Gate Door Operator

NSEE EG22A 24V DC Circuit Control Board PCB Automatic Swing Gate Door Operator
Swing Gate Control Panel. Application:Used for DC swing gate opener. Board Memory: 120 rolling code transmitters. Frequency: 433.92mhz (other frequency customized). Output Voltage: DC 24V. Digital LED Menu brings a easy setting, plug and play. Open/Close single leaf or double leaves. Separate force setting for motor 1, motor 2 and high speed, slow speed brings the motors working accurately. Auto-closing time can be adjusted from 1 second to 99 seconds. Total 60s working time to protect the motors. Terminals available for loop detector, photocell, push button, keypad, access control equipment etc. Compatible with both electric lock and electromagnetic lock. Extra relay out put for lock of pedestrian door or other external devices. Custom rolling code makes the system more secure. Available to connect back up battery or solar system. All swing operators that uses the same board. Our NSEE Swing operators. 1 SIDE terminal is used for connecting any external device that operates single gate. COM terminal is COMMON used for connecting the ground of external devices. 2 SIDE terminal is used for connecting any external device that operates double gate. Swipe Card terminal is used for connecting any external devices that will operate to open the gate. Infrared terminal is used for connecting photo electric sensor. 12V DC output is used for connecting photo electric sensor Continuous output current. 24V battery output is used for connecting the back up battery +. 24V battery output is used for connecting the back up battery. 24V DC output is used for connecting external device. (such as photo electric sensor, max current output 1A). GND is used for connecting the ground of external devices. 24V DC lamp output is used for connecting flash light +. 24V DC lamp output is used for connecting flash light. 24V DC lock outputthe NF terminal which used for connecting the electromechanical lock. COM is COMMON used for connecting the ground of lock. 24V DC lock outputthe NA terminal which used for connecting the magnetic lock. 24V DC alarm output. Motor1 terminal is used for connecting the motor 1 installed on the gate that opens later and close first. This terminal connect 1. Red wire (counted from your left hand side to right hand side). This terminal connect 2. Blue wire (counted from your left hand side to right hand side). Motor2 Delay terminal is used for connecting the motor 2 installed on the gate that opens first and close later. If for single gate, the gate motor just can connect the Motor2 Delay terminal. AC24V input is used for connecting the transformer. Digital display is used for showing you the setting data. INC+ is used for figure increase when setting the data. FUN is used for store the data. DEC- is used for figure decrease when setting the data. Learning button is used for program/remove remote. This swing board mainly used for following swing operators. The item “NSEE EG22A 24V DC Circuit Control Board PCB Automatic Swing Gate Door Operator” is in sale since Sunday, August 27, 2017. This item is in the category “Home & Garden\Home Improvement\Building & Hardware\Garage Doors & Openers\Opener Systems”. The seller is “gate-hardware-and-equipments” and is located in Opa-Locka, Florida. This item can be shipped worldwide.
  • Model: EG22A
  • MPN: EG22A
  • Brand: NSEE
  • Application: Commercial
  • Type: Circuit Control Board PCB Automatic Swing Gate

NSEE EG22A 24V DC Circuit Control Board PCB Automatic Swing Gate Door Operator

Comments are closed.